Viewing Pic 8 of 319
|
| |
| Poster: |
Nik |
| Image: |
Under the sink... |
| Image Details: |
ID: 8451 - Image Type: JPG - Size: 547 x 365 (66KB) |
| BBCode: |
|
| Posted: |
12 Nov 2021 01:48 |
| Views: |
85 |
| Pic Description: |
I cut, pried and pulled a big piece of ''back-board'' out from under sink, could see the ''back-brace'' panel it hid.
To get at the wall and hole --Crater !!-- around thru-wall pipe, I must remove full depth of panel for ~15 inches. But, in a way I can put back to restore full strength...
As attaching mending plates *after* cutting panel might be too difficult, I thought to fit them first, so all the holes would be ready.
I decided on threaded inserts, strong s/steel mending plates and neat s/steel Allen/hex headed bolts. This would allow repeated removal / replacement at need.
I used ''hinge drill'' with telescopic sheath that self-centres in mending plate''s countersinks. Fitted first insert and bolt per plate ''by eye and sharpie''. Tightened plate, used that as template to drill other 7 holes. Swing aside to thru-drill panel and set inserts, swing back to bolt up...
See attached. Will zoom.
Hero of day was my lonnng ''Yankee'' pump-action ratchet screw-driver, which accurately reached, started and wound inserts into their 6 mm pilot holes using H4 bit, then nimbly drove those little bolts using H2.5 bit...
Honourable mention to foot-long 6 mm auger which reached past the plumbing when even a semi-flexible extension would not let my cordless drill near enough...
So, when I next feel brave, I''ll unscrew those bolts, remove their plates, cut the panel with buzz-blade / multi-tool. Take evidence photo, make ''shield'' template. Then replace panel and mending plates until wall has dried enough. Dehumidifier still pulling 2~~3 litres per day...
Spent much of today jig-sawing a part-batten and part-plank into 25-of 4 and 5 inch ''jenga'' sticks to be rungs / cleats on a pair of cat-ramp planks. Beveled exposed edges, hoovered saw-dust. Then realised ramp planks are thinner than usual decking, so I didn''t have any skinny ''decking'' screws the right length. D''uh.
I''d some in premium ''stainless steel'', but I needed 50+. Hastily ordered budget 100-of 4mm x 40 mm (~ #8 x 1½\") ''decking'' screws from Amazon with ''free delivery'' by post...
Never mind, we''ve a succession of storms forecast, and both ramps need angled feet that are running late, ''delayed by short-staffing due Covid''...
Stay Safe, Stay Well,
Nik |
|
Photo Album Powered by:
Mighty Gorgon Full Album Pack 1.5.0 © 2007 [based on
Smartor Photo Album plus IdleVoid's Album CH & CLowN SP1]
Under the sink... 
