Well, I spent some time today trying out the P4 Tunic set, and found a few small issues.
I sent the creator a private message at the site where I found the link; here it is in it's entirety:
"Hello;
I tried out the set in
Poser 5, and discovered some issues.
1.) The tunic "front" & "back" contian unused & therefore unneeded nodes . I don't think that they cause any trouble; but I bet they add unneeded size to the zip.
2.) The belt and boots use displacement, which by itself is good; but the value is so high that it causes them to break apart when rendered. A lower value works well. For my personal tastes, I disconnected the image map from the displacement channel, and connected it instead to the bump channel. I then used a small bump value, and was pleased with the results.
3.) The tunic conforms well to simple poses; but more active poses cause poke through. This of course normal; but the available dials do not offer much assistance in overcoming it.
Asis probably obvious from reading this, these are small problems for me, or any other somewhat experienced
Poser user; but they may be big problems, or viewed as defects in your creation by newer/ less experienced users.
Well, I just wanted to let you know what I thought of your gift; Thank you for sharing your time and talent.
(:"
I'll be sure to post any interesting or important information that I receive in reply.